The importance of correctly replacing the locomotive filter:

Be sure to choose the regular manufacturer's filter, poor quality oil filter on the locomotive damage is huge, not only can not protect the engine, but also cause secondary damage.

Although the process of replacing the oil filter is not complicated, the correct use of professional tools and operation according to the process specifications can ensure the safety of the locomotive during use and the effective protection of the oil filter on the engine.

Tool materials:

* Belt wrench * Socket wrench * One Moo oil filter

Oil filter installation method in different positions:

Different models of motorcycles, the location of the oil filter installation is also different, respectively, the bottom, the top and the horizontal three positions, the installation method of different positions is also different.

Bottom vertical installation:

Fill the oil filter inside with oil. (The purpose of filling the oil is to remove the air in the oil filter, and the flow of the air oil is poor, which is easy to produce resistance, which will cause some parts to lack oil lubrication for a short time, resulting in wear.)

Top vertical installation:

No need to inject oil, can be installed directly.

Horizontal installation:

Inject half the oil into the oil filter, turn a few rounds back and forth at a 45° Angle, fully soak the new filter paper, and then install.

Oil filter replacement steps:

Step 1: Disassembly method

* Since most oil filters are located close to the exhaust pipe, please wear cotton gloves before removing the oil filter to prevent burns.

* When removing the oil filter, clean up the soil debris on the surface of the oil filter and near it to prevent pollutants from entering the filter base and polluting the oil.

* Moo oil filter has intimate bottom cover design, remove the old oil filter quickly cover, can prevent waste oil flow dirty machine, polluting the environment.

Step 2: Installation precautions

* Before installing the oil filter, remove the seal ring of the oil filter and apply the oil on both sides to prevent deformation and oil leakage during installation.

* The oil filter is filled with oil, and soaked for about one minute, and then filled with about 30ml oil (according to the size of the oil filter the amount of oil will change), so that the oil soaked the filter paper inside the oil filter fully; This is because the dry filter on the car, the oil filter may form a vacuum at the moment the vehicle starts, resulting in no oil, or insufficient oil phenomenon, resulting in mechanical component wear, oil light.

* To install the Moo oil filter, you only need to tighten it clockwise with hand force, and then tighten it with the tool about 3/4 turns (torque 18 plus or minus 2) to ensure no oil leakage.

* The tool for installing the oil filter is very important, do not allow the use of any tool that will scratch and deform the oil filter shell, such as a chain wrench, once the oil filter is scratched, it may cause the oil filter to deform, expand, or even directly explode, in this case, the factory is exempt. Belt wrenches and bowl oil filter tools are recommended.

Step 3:

* After the oil filter is installed, drive the car for about 3 minutes to check whether the instrument is abnormally lit.

* Check whether there is leakage around the oil filter, if there is leakage, please check the cause, no leakage is installed.

(Text from the network, infringement please contact delete)